Adding and Connecting Microservices

Adding Microservices

To add microservices, perform the steps below:

1. Open the Micro Service Palette and click the Category tab corresponding to the microservice.

   

   The Search option in the Palette enables retrieval of microservices upon typing the microservice name in it.

2. Drag the business component icon onto the Fiorano Orchestrator editor.

Each icon in the Fiorano Orchestrator editor represents an instance of the microservice. By default, the name of each instance of the microservice is the service GUID followed by the instance ID count (such as chat1 in the figure above). 

Edit the microservice instance name from the Properties window or by pressing F2 key after selecting the icon.

Connecting Routes

For the data to flow between two microservice instances, they need to be linked via Event Routes. The Route represents the Brokered Peer-to-Peer data Route. The Event Routes are unidirectional and always originate at output Event Port of the source microservice and end at input Event Port of the target microservice.

Connect the Route from the output channel (OUT_PORT) of the Chat1 microservice icon to the input channel (IN_PORT) of the Chat2 microservice icon and vice versa, as shown in the figure below. By default, each Route is identified by an Event Route name such as Route1 and Route2. The suffix represents the instance count of the Route.

Edit the Route name from the Properties window or by pressing F2 after selecting the route.

• Refer the Running an Event Process section to go through the steps to run a simple event process.
• To create transformations on the routes connecting microservices, refer the Defining Route Transformations section.